Raise3D Pro2 Software Bug or Hardware Problem

Loading...

Thanks! Share it with your friends!

You disliked this video. Thanks for the feedback!

Added by Arslan
61 Views
Hello,


is there a software bug or a hardware problem

The following has happened to me before ... had solved itself after a restart again independently, as of today no restart helps. It is NOT unloaded.
A reset at the touch display didnt bring any success.
I want to unload a filament ... after I click on unload, first a little filament is preloaded and then unloaded.
Here ONLY preloading is done and NOT unloading ... if I dont watch out the whole coil will be used up.
What is going on here
How do I get the filament changed without trial and error
I think this has only appeared since the latest firmware/touch update.

Translated with www.DeepL.com/Translator Raise3D Pro2 Software Bug or Hardware Problem
Category
Technology
Tags
Raise3D Pro2 Software Bug or Hardware Problem

Post your comment